IBM 867431X Hardware Maintenance Manual - Page 82
Setting up point-to-point protocol, Baud Rate, Parity, Stop Bits, Exit Utility
View all IBM 867431X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Note: The values in the following window are only examples; your settings will be different. 6. Verify the following serial port values: Baud Rate The default is 57600. Make sure that the baud rate matches the baud rate of the device you are connecting to the serial port on the Remote Supervisor Adapter. Parity The default is None. Stop Bits The default is 1. Note: The data bits value is preset to 8 and cannot be changed. For detailed information about the serial port and modem settings, see the IBM Remote Supervisor Adapter User's Guide for the xSeries 330. 7. If you make changes to the serial port settings, press F6 to apply the changes. 8. Press Esc to return to the Configuration Settings window. 9. If you need to set up PPP, go to "Setting up point-to-point protocol"; otherwise, continue with step 10. 10. Press Esc to return to the Utility program main window. 11. Use the arrow keys to select Exit Utility from the menu or press Esc to close the Utility program. 12. Remove the CD from the CD-ROM drive. The Remote Supervisor Adapter restarts automatically. Continue with "Setting up point-to-point protocol" on page 74. Setting up point-to-point protocol The Remote Supervisor Adapter serial port supports point-to-point protocol (PPP). The PPP enables TCP/IP communication over the serial port, which enables Web-based management and TELNET sessions over a modem. To set up PPP, complete the following steps: 74 Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building System Type 8674