IBM 867431X Hardware Maintenance Manual - Page 73
Connecting the power-supply adapter
View all IBM 867431X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Attention: Route cables so that they do not block the flow of air from the fans. 8. Replace the cover on the server; then, reinstall the server in the rack (if applicable) and connect all external cables. 9. Connect the ASM Interconnect module to the Remote Supervisor Adapter using the ASM Interconnect port (P-P port) that is located on the adapter. 10. Connect one end of the ASM link cable (Category 5 cable) to the ASM Interconnect module, and the other end to the ASM Interconnect port that is located on the back of your server. P - P ASM link cable ASM Interconnect module 11. Turn on the server. Continue with "Connecting the power-supply adapter". Connecting the power-supply adapter You may attach the power-supply adapter that comes with the Remote Supervisor Adapter. After you connect the power supply adapter to the Remote Supervisor Adapter, you can use the power cord to connect the power supply adapter to a properly grounded electrical outlet or use the universal power cord (comes with the Remote Supervisor Adapter) to connect the power supply adapter to a power distribution unit (PDU) or to an uninterruptible power supply (UPS). Note: Alternatively, power can be supplied to the adapter by connecting the system-management connector of the adapter to the Remote Supervisor Adapter connector (J57) on the system board using the 20-pin ribbon cable that comes with the adapter. To connect the power-supply adapter and power cord, complete the following steps: 1. From the power-supply adapter 3 , connect the power-supply control cable 2 to the power-supply adapter connector on the Remote Supervisor Adapter Installing options 65