Icom IC-7600 Instruction Manual - Page 129

SET MODE 10 SSB TBW (WIDE) Sets the transmission passband width to a wide setting by changing the lower and higher cut-off frequencies. 100 - 2900 • Lower freq. : 100 (default), 200, 300 and 500 Hz • Higher freq. : 2500, 2700, 2800 and 2900 Hz (default) SSB TBW (MID) 300 - 2700 Sets the transmission passband width to a middle • Lower freq. : 100, 200, 300 (default) and 500 Hz setting by changing the lower and higher cut-off fre- • Higher freq. : 2500, 2700 (default), 2800 quencies. and 2900 Hz 1 SSB TBW (NAR) 500 - 2500 2 Sets the transmission passband width to a narrow • Lower freq. : 100, 200, 300 and 500 Hz (default) 3 setting by changing the lower and higher cut-off fre- • Higher freq. : 2500 (default), 2700, 2800 quencies. and 2900 Hz 4 Drive Gain 50% 5 Sets the drive gain level from 0% to 100% in 1% 6 steps. (default: 50%) While talking into the microphone, keying down or transmitting, rotate the main dial so that the ALC 7 meter reading is between 30% to 50% of the ALC scale. (p. 37) 8 The drive gain is active for all modes other than SSB 9 mode with speech compressor OFF. 10 Speech Level 50% 11 Sets the voice synthesizer audio output level from 0% to 100% in 1% steps. (default: 50%) 12 Side Tone Level 50% 13 Sets the sidetone output level from 0% to 100% in 14 1% steps. (default: 50%) 15 Side Tone Level Limit ON 16 Turns the sidetone output level limiting capability ON • OFF : CW sidetone level is linked to the [AF] con- and OFF. (default: ON) trol. 17 When this item is set to ON, the CW sidetone is linked to the [AF] control until rotation of the [AF] • ON : CW sidetone level is limited with the [AF] control. 18 control reaches to the specified level-further rota- tion will not increase the volume of the CW sidet- 19 ones. 20 ☞ Continues to the next page. 21 122