Icom IC-7600 Instruction Manual - Page 8

1 PANEL DESCRIPTION ■ Front panel q w e r t y TIMER POWER HF/50MHz TRANSCEIVER TRANSMIT PHONES TUNER MONITOR BAL NR ELEC-KEY NB NR AF RF/SQL MIC MIC GAIN RF POWER BK-IN DELAY KEY SPEED TX RX SPLIT LOCK SPLIT 1.8 1 3.5 2 7 3 10 4 14 5 18 6 DUAL WATCH 21 7 24 8 28 9 CHANGE GENE 50 0 F-INP ENT MAIN /SUB MP-W MW MP-R VFO/MEMO XFC TS TWIN-PBT PBT-CLR NOTCH APF/TPF NOTCH CW PITCH F-1 SSB F-2 F-3 F-4 F-5 F-6 AUTO TUNE CW RTTY/PSK AM / FM FILTER EXIT/SET REC PLAY VOICE MEMORY RIT ӠTX CLEAR RIT/ӠTX SPEECH LOCK u i o !0 q POWER SWITCH [POWER•TIMER] (p. 30) While transceiver's power is OFF: ➥ Push to turn the transceiver power ON. • Turn the optional DC power supply ON in advance. • The indicator on this switch lights green when powered ON. While transceiver's power is ON: ➥ Push momentarily to toggle the timer function ON and OFF. (p. 117) • The timer indicator appears when the timer function is ON. (If the transceiver's power is OFF, the indicator on this switch lights red.) ➥ P ush and hold for 1 sec. to turn the transceiver power OFF. w TRANSMIT SWITCH [TRANSMIT] Selects transmit or receive. • The [TX] indicator lights red while transmitting and the [RX] indicator lights green when the squelch is open. e HEADPHONE JACK [PHONES] Accepts standard stereo headphones (impedance: 8 to 16 ø). • Output power: 5 mW with an 8 ø load. • When headphones are connected, the internal speaker or connected external speaker does not function. r ELECTRONIC KEYER JACK [ELEC-KEY] Accepts a paddle to activate the internal electronic keyer for CW operation. (p. 17) • Y ou can select internal electronic keyer, bug-key or straight key operation in keyer set mode screen. (p. 44) • A straight key jack is located on the rear panel. See [KEY] on p. 12. • Keyer polarity (dot and dash) can be reversed in keyer set mode screen. (p. 45) • A 4-channel memor y keyer is available for your convenience. (p. 41) (dot) (com) (dash) t U SB (Universal Serial Bus) CONNECTOR (A type) [USB] (A) (p. 19) ➥ Insert USB-Memory* for both reading/storing a wide variety of the transceiver's information and data. • The indicator above the connector lights or blinks when the transceiver reads or writes to the memory data. • Unmount operation should be performed before removing the USB-Memory* (p.142). ➥ Connects a PC keyboard for RTTY and PSK operations, etc. • Only USB keyboards* are supported. *: USB-Memory and USB keyboard are not supplied by Icom.