Icom IC-7600 Instruction Manual - Page 75
Scope, during, CENTER, Display, Filter, Sweep, Speed, Waveform, Color, Current
View all Icom IC-7600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
4 RECEIVE AND TRANSMIT Scope during Tx (CENTER Type) Turn display of the transmit signal ON and OFF. Max Hold Turn the peak level hold function ON and OFF. ON NOTE: Transmit signal display is available for the center mode only. ON CENTER Type Display Select the center frequency of the spectrum scope indication (center mode only). Waveform Color (Current) Set the waveform color for the currently received signals. Waveform Color (Max Hold) Set the waveform color for the received signals maximum level. Sweep Speed (± 2.5k) Select the sweep speed for the ±2.5 kHz span selection from SLOW, MID and FAST. Sweep Speed (± 5k) Select the sweep speed for the ±5 kHz span selection from SLOW, MID and FAST. Sweep Speed (± 10k) Select the sweep speed for the ±10 kHz span selection from SLOW, MID and FAST. Filter Center • Filter Center : Shows the selected filter's center frequency at the center. • Carrier Point Center : Shows the selected operating mode carrier point frequency at the center. • Carrier Point Center (Abs. Freq.) : In addition to the carrier point center setting above, the actual frequency is displayed for the bottom of the scope. 217 241 247 • The color is set in RGB format. • Push [Ω ≈] (F-3) to select R (Red), G (Green) and B (Blue), and rotate the ratio from 0 to 255 range. • The set color is indicated in the box beside the RGB scale. 58 110 147 • The color is set in RGB format. • Push [Ω ≈] (F-3) to select R (Red), G (Green) and B (Blue), and rotate the ratio from 0 to 255 range. • The set color is indicated in the box beside the RGB scale. MID NOTE: Signals may be displayed incorrectly with "FAST" setting. MID NOTE: Signals may be displayed incorrectly with "FAST" setting. FAST ☞ Continues to the next page. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 68