Icom IC-7600 Instruction Manual - Page 38
◇ Band edge warning beep, EXIT/SET], SET] F-6, OTHERS] F-5, BAND], BAND] F-5 - performance
View all Icom IC-7600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
3 BASIC OPERATION D Band edge warning beep When you tune inside or outside of an amateur band's frequency range, a warning beep sounds. (" " may be indicated on outside of an amateur band's fre- quency.) (p. 14) This function can be turned OFF in set mode, if desired. q P ush [EXIT/SET] several times to close a multifunction screen, if necessary. w Push [SET] (F-6) to select set mode menu screen. • Pushing and holding [EXIT/SET] for 1 sec. also selects set mode menu screen. e Push [OTHERS] (F-5) to enter others set mode. r P ush [Y] (F-1) or [Z] (F-2) to select "Beep (Band Edge)." t R otate the main dial to select the band edge warn- ing beep function. y Push [EXIT/SET] to exit the set mode. The beep output level can be set in level set mode. (p. 123) When the transverter function is in use, the band edge warning beep sounds with the default setting. OTHERS SET F-5 F-6 F-1 F-2 EXIT/SET Main dial When the band edge warning beep is set to "ON": The band edge warning beep sounds (enter: Pi, exit: Bu) according to the set mode setting as follows. • ON (Default) Band edge beep sounds when an operating frequency enters or exits the default amateur band. (default) • ON (User) A beep sounds when an operating frequency enters or exits an amateur band that is set in band edge screen. • ON (User) & TX Limit Same as the setting of "ON (User)." However, the transmission can be made in the set frequency range only. ON (Default) (default) Appears ON (User) To programming the band edge: When "ON (User)" or "ON (User) & TX Limit" is selected, [BAND] appears in the display above the function switch (F-5), and up to 30 band edge frequencies can be set in band edge screen. [DEL] [INS] BAND / OK F-5 Keypad q P erform the steps q to t as above, then select "ON (User)" or "ON (User) & TX Limit." w P ush [BAND] (F-5) to enter the band edge screen. e P ush [Y] (F-1) or [Z] (F-2) to select the desired band edge. • Push [Ω ≈] (F-3) to select the set content for band F-1 F-2 F-3 F-4 EXIT/SET Main dial DEF edge, lower or upper. • Push [INS] (MF6) to insert a new blank band edge line. • Band edge screen • Push and hold [DEL] (MF7) for 1 sec. to delete the selected band edge line. • Push and hold [DEF] (F-4) for 1 sec. to display the band edge initialize screen. Then, push and hold [OK] (F-5) to initialize all band edge frequency settings. r Input the desired frequency with the keypad. • Push [GENE •] to input ". (decimal point)" between the NOTE: All frequency ranges are set in default. So MHz units and kHz units. you should delete or change it to add the desired • Program the frequency in ascending order. band edge frequency. • The frequency that is duplicated or out of an amateur band cannot be programmed. 31 t Push [EXIT/SET] to exit the set mode.