Kyocera KM-C2030 KM-C3130/C2030 Operation Guide Basic Oper Rev-1B - Page 12

Before Making Copies Chapter 1 1.2 Available Features 1 Finishing Settings Stapling Copies are stapled together before they are fed out. Stapling is only available if the optional finisher (DF-625 or DF-620) is installed. Hole-punching Holes are punched in copies before they are fed out. Hole-punching is only available if the punch kit (PH-620) is installed in the optional finisher (DF-625). Zoom Settings Auto Size G This setting automatically selects the most appropriate zoom ratio based on the size of the document loaded and the specified paper size. Full Size G This setting makes a copy that is the same size as the document (× 1.000). Enlarged copies G Zoom settings for making enlarged copies from common standard document sizes to standard paper sizes are available. ❍ Example 1: A Letter-size document can be copied onto the larger 11 × 17-size paper. ❍ Example 2: A Legal-size document can be copied onto the larger 11 × 17-size paper. Reduced copies G Zoom settings for making reduced copies from common standard document sizes to standard paper sizes are available. ❍ Example 1: A Legal-size document can be copied onto the smaller Letter-size paper. ❍ Example 2: An 11 × 17-size document can be copied onto the smaller Lettersize paper. Minimal G This setting slightly reduces the copy (×0.930). ❍ Selecting the "Minimal" setting ensures that any part of the original positioned at the edge of the page will not be cut off in the copy. Zoom copies G Any zoom ratio (between ×0.250 and ×4.000) can be specified. ❍ Touch and to specify the desired zoom ratio. 1-5