Kyocera KM-C2030 KM-C3130/C2030 Operation Guide Basic Oper Rev-1B - Page 93
To specify Finishing settings
View all Kyocera KM-C2030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
5 5.2 Selecting a Finishing Setting G If nonstandard-size paper is used, the paper length must be between 7-1/4 in. and 17 in. G The copier must not enter Interrupt mode. To specify Finishing settings Specifying Copy Settings Chapter 5 1 Touch [Finishing]. A screen appears, showing the available Finishing settings. 2 Select the desired Finishing settings. 3 When "2-Hole Punch" or "3-Hole Punch" is selected, the [Change Position] key appears. 4 Touch [Change Position]. The Change Position screen appears. 5 Select the desired position for the punched holes, and then touch [Enter]. 5-6
5
5.2 Selecting a Finishing Setting
5-6
Specifying Copy Settings
Chapter 5
±
If nonstandard-size paper is used, the paper length must be between 7-1/4 in.
and 17 in.
±
The copier must not enter Interrupt mode.
To specify Finishing settings
1
Touch [Finishing].
A screen appears, showing the available Finishing settings.
2
Select the desired Finishing settings.
3
When
“
2-Hole Punch
”
or
“
3-Hole Punch
”
is
selected, the [Change
Position] key appears.
4
Touch [Change Position]. The
Change Position screen appears.
5
Select the desired position for the punched holes, and then touch [Enter].