Netgear GSM7224v1 GSM7212 Command line reference manual - Page 154
storm-control multicast all, storm-control unicast all
View all Netgear GSM7224v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver- 9.2.1.1 no storm-control broadcast This command disables broadcast storm recovery mode. The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port exceeds the high threshold percentage (as represented in Table 9-1) of the link speed, the switch discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or less. The full implementation is depicted in the Table 9-1. Format no storm-control broadcast Mode Global Config 9.2.2 storm-control multicast all This command enables multicast storm recovery mode. If the mode is enabled, multicast storm recovery with hight and low thresholds is implemented. The thresholds are defined in the same way as for broadcast. Default disable Format storm-control multicast all Mode Config 9.2.2.1 no storm-control multicast all This command disables multicast storm recovery mode. Format no storm-control multicast all Mode Global Config 9.2.3 storm-control unicast all This command enables unknown unicast packet storm recovery mode. If the mode is enabled, the unknown storm recovery with high and low thresholds is implemented. The thresholds are defined same as the one for broadcast. Default disable Format storm-control unicast all Mode Config 9-6 Port-Based Traffic Control Commands v1.0, February 2007