Netgear GSM7224v1 GSM7212 Command line reference manual - Page 273
logging console, logging host, logging host remove
View all Netgear GSM7224v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 273 highlights
Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver- 15.3.3 logging console This command enables logging to the console. You can specify the value as either an integer from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), informational (6), or debug (7). Default disabled; critical Format logging console [severitylevel] Mode Global Config 15.3.3.1 no logging console This command disables logging to the console. Format no logging console Mode Global Config 15.3.4 logging host This command enables logging to a host. You can configure up to eight hosts. The is the IP address of the logging host. The value is a port number from 1 to 65535. You can specify the value as either an integer from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), informational (6), or debug (7). Default port - 514; level - critical; Format logging host [][] Mode Global Config 15.3.5 logging host remove This command disables logging to host. See Section 15.3.11 "show logging hosts" on page 15-26 for a list of host indexes. Format logging host remove Mode Global Config System Maintenance Commands v1.0, February 2007 15-23