Netgear GSM7224v1 GSM7212 Command line reference manual - Page 155
storm-control broadcast, storm-control multicast
View all Netgear GSM7224v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver- 9.2.3.1 no storm-control unicast all This command disables multicast storm recovery mode. Format no storm-control unicast all Mode Global Config 9.2.4 storm-control broadcast This command enables broadcast storm recovery mode in per-port level. If the mode is enabled, broadcast storm recovery with high and low thresholds is implemented. The value is in a range of 0 to 100 (in percentage). A value of 0 means no storm control. If the value is not specified, the thresholds are defined the same as the ones for broadcast storm control in Global mode. Default enable Format storm-contol broadcast [] Mode Interface Config 9.2.4.1 no storm-control broadcast This command disables broadcast storm recovery mode. Format no storm-control broadcast [] Mode Interface Config 9.2.5 storm-control multicast This command enables multicast packet storm recovery mode on the port level. If the mode is enabled, multicast storm recovery with high and low thresholds is implemented. The value is in a range of 0 to 100 (in percentage). Value of 0 means no storm control. If value is not specified, the thresholds are defined same as the ones for broadcast storm control in Global mode. Default enable Format storm-control multicast [] Mode Interface Config Port-Based Traffic Control Commands 9-7 v1.0, February 2007