Netgear GSM7224v1 GSM7212 Command line reference manual - Page 226
<address> <macmask>
View all Netgear GSM7224v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 226 highlights
Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver- 14.3.13 match protocol This command adds to the specified class definition a match condition based on the value of the IP Protocol field in a packet using a single keyword notation or a numeric value notation. To specify the match condition using a single keyword notation, the value for is one of the supported protocol name keywords. The currently supported values are: icmp, igmp, ip, tcp, udp. A value of ip is matches all protocol number values. To specify the match condition using a numeric value notation, the protocol number is a standard value assigned by IANA and is interpreted as an integer from 0 to 255. Note: This command does not validate the protocol number value against the current list defined by IANA. Format Mode match protocol {protocol-name | } Class-Map Config 14.3.14 match source-address mac This command adds to the specified class definition a match condition based on the source MAC address of a packet. The parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The parameter is a layer 2 MAC address bit mask, which may not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc). Default none Format match source-address mac Mode Class-Map Config 14.3.15 match srcip This command adds to the specified class definition a match condition based on the source IP address of a packet. The parameter specifies an IP address. The parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits. Format match srcip Mode Class-Map Config 14-16 Quality of Service (QoS) Commands v1.0, February 2007