Netgear GSM7224v1 GSM7212 Command line reference manual - Page 91
spanning-tree configuration revision, spanning-tree edgeport, spanning-tree edgeport all
View all Netgear GSM7224v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver- 5.1.4 spanning-tree configuration revision This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch is currently using. The Configuration Identifier Revision Level is a number in the range of 0 to 65535. Default 0 Format spanning-tree configuration revision Mode Global Config 5.1.4.1 no spanning-tree configuration revision This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch is currently using to the default value, i.e. 0. Format no spanning-tree configuration revision Mode Global Config 5.1.5 spanning-tree edgeport This command specifies that this port is an Edge Port within the common and internal spanning tree. This allows this port to transition to Forwarding State without delay. Format spanning-tree edgeport Mode Interface Config 5.1.5.1 no spanning-tree edgeport This command specifies that this port is not an Edge Port within the common and internal spanning tree. Format no spanning-tree edgeport Mode Interface Config 5.1.6 spanning-tree edgeport all This command specifies that every port is an Edge Port within the common and internal spanning tree. This allows all ports to transition to Forwarding State without delay. Format spanning-tree edgeport all Mode Global Config Spanning Tree Protocol Commands 5-3 v1.0, February 2007