Home » Panasonic Manuals » Multifunction Devices » Panasonic KX-FLB851 » Manual Viewer

Panasonic KX-FLB851 Multi-function Laser Fax - Page 71

Help, Error Messages, JUNK FAX PROH. REJECT

UPC - 037988809851

View all Panasonic KX-FLB851 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 71 highlights

9. Help 9 Help 9.1 Error messages - Reports If a problem occurs during fax transmission or reception, one of the following messages will be printed on the confirmation and journal reports (page 27). Message COMMUNICATION ERROR DOCUMENT JAMMED ERROR-NOT YOUR UNIT JUNK FAX PROH. REJECT MEMORY FULL NO DOCUMENT / FAILED PICKUP OTHER FAX NOT RESPONDING PRESSED THE STOP KEY THE COVER WAS OPENED OK Code 40-42 46-72 FF 43 44 ----54 59 70 --------- --------- Cause & Solution L A transmission or reception error occurred. Try again or check with the other party. L A line problem occurred. Connect the telephone line cord to a different jack and try again. L An overseas transmission error occurred. Try using the overseas mode (feature #411 on page 63). L The document is jammed. Remove the jammed document (page 85). L A transmission or reception error occurred because of a problem with the other party's fax machine. Check with the other party. L The junk fax prohibitor feature of this unit rejected fax reception. L The memory is full of received documents due to a lack of recording paper or a recording paper jam. Install paper (page 15) or clear the jammed paper (page 82). L If you select the computer that will be used for receiving a fax in feature #443 (page 67), and feature #442 is set to "ALWAYS" (page 65), check the connection between the computer and the unit. L The document was not fed into the unit properly. Re-insert it and try again. L The other party's fax machine is busy or has run out of recording paper. Try again. L The other party's fax machine rings too many times. Send the fax manually (page 26). L The other party's machine is not a fax machine. Check with the other party. L The number you dialed is not in service. L {STOP} was pressed and fax communication was canceled. L The top cover was opened. Close it and try again. L Fax transmission or reception was successful. For assistance, please visit http://www.panasonic.com/consumersupport 69

Section	Page
Location of Controls	2
Location of Controls	2
Location of controls	3
Important Information	5
Safety Instructions	5
Important safety instructions	5
For best performance	7
Table of Contents	8
Introduction and Installation	10
Accessories	10
1.2 Accessory information	11
Finding the Controls	11
1.3 Description of buttons	11
1.4 Overview	12
Installation	14
1.5 Toner cartridge and drum unit	14
1.6 Document tray	16
1.7 Output tray	16
1.8 Recording paper	17
Preparation	21
Connections and Setup	21
2.1 Connections	21
2.2 Turning the power switch ON	22
2.3 Dialing mode	22
2.4 Selecting the operation mode (Fax/Copy/Scan)	23
Help Button	23
2.5 Help function	23
Volume	23
2.6 Adjusting volume	24
Initial Programming	24
2.7 Date and time	24
2.8 Your logo	25
2.9 Your fax number	27
Fax	28
Sending Faxes	28
3.1 Using the unit as a fax machine	28
3.2 Sending a fax manually	28
3.3 Document requirements	30
3.4 Storing names and telephone numbers for the one-touch dial feature and navigator directory	31
3.5 Sending a fax using one-touch dial feature and navigator directory	33
3.6 Broadcast transmission	34
Receiving Faxes	35
3.7 Receiving a fax automatically – Auto answer ON	36
3.8 Receiving a fax manually – Auto answer OFF	36
3.9 Using the unit with an answering machine	37
3.10 Junk fax prohibitor (preventing fax reception from undesired callers)	38
Caller ID	40
Caller ID	40
4.1 Caller ID service	40
4.2 Viewing and calling back using caller information	40
4.3 Storing caller information into the one- touch dial feature and navigator directory	41
Distinctive Ring	43
Distinctive Ring	43
5.1 Distinctive Ring service from your phone company	43
5.2 Using two or more phone numbers on a single telephone line	43
5.3 Using three or more phone numbers on a single telephone line	43
5.4 Programming the ring pattern assigned for fax	44
Copy	45
Copying	45
6.1 Using the unit as a copy machine	45
6.2 Making a copy	45
6.3 More copying features	47
Multi-Function Station software	49
Setup	49
7.1 Connecting to a computer	49
7.2 Installing Multi- Function Station	49
7.3 Starting Multi-Function Station	51
Printing	51
7.4 Using the unit as a printer	51
Scanning	54
7.5 Using the unit as a scanner	54
Remote Control	55
7.6 Operating the unit from your computer	55
PC Fax	56
7.7 Fax sending/receiving using Multi-Function Station	56
7.8 Confirming the status of the unit	57
7.9 Other information	57
Programmable Features	59
Features Summary	59
8.1 Programming	59
8.2 Direct command chart	60
8.3 Basic features	63
8.4 Fax features	65
8.5 Copy features	68
8.6 Scan features	69
8.7 LAN features	69
Help	71
Error Messages	71
9.2 Error messages – Display	72
Troubleshooting	75
9.3 When a function does not work, check here	75
Replacement	81
9.4 Replacing the toner cartridge and the drum unit	81
Jams	84
9.5 Recording paper jam	84
9.6 Document jams (Auto document feeder)	87
Cleaning	88
9.7 Cleaning the white plate and glasses	88
9.8 Cleaning the document feeder rollers	92
General Information	93
Printed Reports	93
10.1 Reference lists and reports	93
Specifications	94
10.2 Specifications	94
FCC and Other Information	97
10.3 FCC and Other Information	97
Limited Warranty	99
10.4 Limited Warranty	99
Customer Services	101
10.5 Customer Services directory	101
Copyrights	102