Ricoh SP4100N Operating Instructions - Page 149
Attaching Memory Unit Type C 128MB/256MB SDRAM Module., The printer identified a USB I/F Board error.
UPC - 026649027994
View all Ricoh SP4100N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
Error & Status Messages on the Control Panel Hardware Problem Ethernet The printer detected an ethernet error. • Turn the power off, and then on. If the message appears again, contact your sales or service representative. Hardware Problem HDD The printer identified a HDD Board error. • Turn the power off, and then on. Remove and re-install the HDD board correctly. If the message appears again, contact your sales or service representative. • See p.27 "Attaching Hard Disk Drive Type 2650". Hardware Problem Option RAM The printer detected an optional RAM error. • Turn the power off, and then on. Remove and re-install the optional RAM. If the message appears again, contact your sales or service representative. • See p.29 "Attaching Memory Unit Type C 128MB/256MB (SDRAM Module)". Hardware Problem Parallel I/F The printer identified a parallel interface error. • Check the correct interface cable being used. • Turn the power off, and then on. If the message appears again, contact your sales or service representative. Hardware Problem Printer font The printer identified a printer font file error. 9 • It is necessary to replace the printer font module. Hardware Problem USB The printer identified a USB I/F Board error. • Turn the power off, and then on. If the message appears again, contact your sales or service representative. Hardware Problem Wireless Board Access to the IEEE 802.11b board is possible, but an error was detected. • Check that the board is installed correctly. If the message appears again, contact your sales or service representative. • See p.33 "Attaching IEEE 802.11b Interface Unit". Hardware Problem Wireless Card Access to the IEEE 802.11b interface unit is possible, but an error was detected. 147