Ricoh SP4100N Operating Instructions - Page 34
Fasten the controller board to the printer with the two screws.
UPC - 026649027994
View all Ricoh SP4100N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
2. Installing Options 10. Fasten the controller board to the printer with the two screws. 2 AUB209S • Use a coin or similar object if the screws do not turn easily. • After finishing the installation, you can check the memory unit is properly installed: Print the configuration page from the [List/Test Print] menu. If it is installed properly, the memory capacity will appear under "Total Memory" on the configuration page. • The table below shows the total SDRAM module capacities. Standard 128 MB*1 128 MB*1 Extended 128 MB 256 MB Total 256 MB 384 MB • *1 Value when the default SDRAM module (64 MB) is removed • If the memory unit is not properly installed, repeat this procedure. If you cannot install it properly even after reinstallation, contact your sales or service representative. • Install the controller board carefully to prevent any malfunction. • "Printing the Test Page", Quick Installation Guide. 32