Singer SE340 LEGACY Instruction Manual and Troubleshooting Guide - Page 20
Caution
View all Singer SE340 LEGACY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
THREADING THE MACHINE THREADING THE NEEDLE EYE CAUTION 7RSUHYHQWDFFLGHQWV .HHS¿QJHUVDZD\IURPDOOPRYLQJSDUWV6SHFLDOFDUH LVUHTXLUHGDURXQGWKHQHHGOH 2. Do not lower the threader lever while machine is operating. NOTE: The needle threader is used for needle sizes 11/80, 14/90, and 16/100. DRAWING UP THE BOBBIN THREAD This machine can start to sew without drawing up the bobbin thread. If you want to start sewing with longer bobbin thread, draw up the bobbin thread as follows. 1. Insert the bobbin into the bobbin holder as shown on page 18, but do not cut thread. 2. Raise the presser foot. 3. Hold upper thread loosely and turn hand wheel toward you one complete revolution. 1. Lower the presser foot. 2. Check that the needle is raised to its highest position. If it is not, raise needle by turning the handwheel toward you. 3. Lower the threader slowly and draw thread through thread JXLGHD DQGSXOOWRZDUGWKHULJKW 4. Push the lever as far as it will go. The threader will turn and the hook pin will go through the needle eye. 5. Draw the thread into the guide, making sure it is under the hook pin. 4. Pull upper thread lightly. Bobbin thread will come up in a loop. 3XOOERWKXSSHUDQGEREELQWKUHDGVDERXWFPLQFKHV toward the back of presser foot. 6. Hold thread loosely and swing back the lever. As the threader rotates back, the hook pin will pass throughthe needle eye, forming a loop of thread. 3XOOWKUHDGRXWDERXWFPLQFKHV WKURXJKWKHQHHGOH eye. 5HSODFHWKHEREELQFRYHU6HHSDJH 20