TP-Link TD-W8950ND User Guide - Page 55
Queue Config, 4.5.6.2 QoS Classification
UPC - 845973060404
View all TP-Link TD-W8950ND manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
TD-W8950ND 150Mbps Wireless Lite N ADSL2+ Modem Router User Guide 4.5.6.1 Queue Config Choose "Advanced Setup→Quality of Service→Queue Config", you can set configure QoS queues on the screen below. Figure 4-54 Click the Add button in Figure 4-54, and you can configure the QoS queue entry on the next screen as shown in Figure 4-55. Figure 4-55 ¾ Queue Configuration Status: Enable or disable the queue configuration. ¾ Queue: Select a QoS queue entry from the drop-down list. ¾ Queue Precedence: Specify precedence for this QoS queue entry. After you specify the condition, click Save/Apply to save the entry and then you will see you settings as shown in Figure 4-54. ) Note: 1) Lower integer values for precedence imply higher priority for this queue relative to others. 2) The queue entry configured here will be used by the classifier to place ingress packets appropriately. 4.5.6.2 QoS Classification This section will guide you to create a traffic class rule to classify the upstream traffic, assign queue which defines the precedence and the interface and optionally overwrite the IP header DSCP byte. A rule consists of a class name and at least one condition below. All of the specified conditions in this classification rule must be satisfied for the rule to take effect. 48