Toshiba D-R4SU Owners Manual - Page 20

Before operating this recorder - manual

Get Toshiba D-R4SU PDF manuals and user guides View all Toshiba D-R4SU manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Introduction Before operating this recorder Is your recorder ready? • Refer to "INSTALLATION GUIDE" and finish the necessary preparations. • Turn on the connected equipment such as a TV or audio system and select the input from the recorder. Turning the power on (This owner's manual instructions are based on the premise that all proper connections have been completed and the TV is turned on.) Press ON/STANDBY on the front panel of the recorder or on the remote control. ON/STANDBY button Loading a disc Check disc compatibility beforehand ( and use a proper playable disc. page 6, 7) Caution • Keep your fingers well clear of the disc tray. Neglecting this may cause serious personal injury. Keep a close watch on children. • Do not use a cracked, deformed, or repaired disc. 1 Open the disc tray. Press on the front panel or OPEN/CLOSE on the remote control. LED ON/STANDBY button button OPEN/CLOSE button CH button When the power turns on, the LED on the front panel illuminates. After a few seconds, a start-up screen appears. The following icon appears at the top right corner of the screen. e.g. Loading When this icon disappears, the recorder is ready to operate. If the disc drive contains a disc, it takes a little longer to start up. Viewing TV channels through this recorder After turning the power on, the recorder will output TV channel signals to the connected TV (also in the stop mode). You can select a desired channel by pressing the CH button, or the number buttons. 2 Insert a disc. Disc without a cartridge Insert with the playback side down. There are two kinds of disc size. Place a disc to fit the guide. If a disc is out of the guide, it may result in damage to the disc or malfunction. Place a disc in the inside hollow. 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
20
Is your recorder ready?
•
Refer to
“
INSTALLATION GUIDE
”
and finish the
necessary preparations.
•
Turn on the connected equipment such as a TV or
audio system and select the input from the recorder.
Turning the power on
(This owner
’
s manual instructions are based on
the premise that all proper connections have been
completed and the TV is turned on.)
Press ON/STANDBY on the front panel of the
recorder or on the remote control.
When the power turns on, the LED on the front panel
illuminates.
After a few seconds, a start-up screen appears.
The following icon appears at the top right corner of
the screen.
When this icon disappears, the recorder is ready to
operate.
If the disc drive contains a disc, it takes a
little longer to start up.
Viewing TV channels through this recorder
After turning the power on, the recorder will output TV
channel signals to the connected TV (also in the stop
mode).
You can select a desired channel by pressing the CH
button, or the number buttons.
Loading
e.g.
Loading a disc
Check disc compatibility beforehand (
page 6, 7)
and use a proper playable disc.
Caution
•
Keep your fingers well clear of the disc tray. Neglecting this
may cause serious personal injury.
Keep a close watch on
children.
•
Do not use a cracked, deformed, or repaired disc.
1
Open the disc tray.
Press
on the front panel or OPEN/CLOSE on
the remote control.
2
Insert a disc.
Disc without a car
tr
idge
Insert with the playback side down.
There are two kinds of disc size. Place a disc to fit
the guide. If a disc is out of the guide, it may result
in damage to the disc or malfunction.
Place a disc in the
inside hollow.
Introduction
Before operating this recorder
OPEN/CLOSE button
button
ON/STANDBY button
LED
ON/STANDBY button
CH button