Yamaha 01V Owner's Manual - Page 152
DYNA.PHASER, REV+CHORUS, Dynamically controlled phaser., Reverb and chorus effects in parallel.
View all Yamaha 01V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
148 Chapter 12-Effects DYNA.PHASER Dynamically controlled phaser. Parameter Range Description SOURCE SENSE FB GAIN OFFSET DIR. STAGE DECAY INPUT, MIDI Control source: input signal or MIDI note on velocity 0-100 Sensitivity -99 to +99% Feedback gain (plus values for normal-phase feedback, minus values for reverse-phase feedback) 0-100 Lowest phase-shifted frequency offset UP, DOWN Upward or downward frequency change 2, 4, 8, 10, 12, 14, 16 Number of phase shift stages *1 Decay speed 1. 6.0 ms-46.0 s (fs=44.1 kHz), 5.0 ms-42.3 s (fs=48kHz) REV+CHORUS Reverb and chorus effects in parallel. Parameter Range Description REV TIME INI.DLY HI.RATIO DENSITY FREQ. NOTE 0.3-99.9 s 0.0-500.0 ms 0.1-1.0 0-100% 0.05-40.00 Hz *1 Reverb time Initial delay before reverb begins High-frequency reverb time ratio Reverb density Modulation speed Used in conjunction with TEMPO to determine FREQ. DEPTH MOD.DLY WAVE REV/CHO HPF LPF TEMPO*2 0-100% Modulation depth 0.0-500.0 ms Modulation delay time Sine, Tri Modulation waveform 0-100% Reverb and chorus balance (0% = chorus, 100% = reverb) Thru, 21 Hz-8.0 kHz High-pass filter cutoff frequency 50 Hz-16.0 kHz, Thru Low-pass filter cutoff frequency 25-300 bps Used in conjunction with NOTE to determine FREQ. 1. 2. For more information about the FREQ., NOTE, and TEMPO parameters, see "Setting Delay, Freq, Note & Tempo Parameters" on page 137. 01V-Owner's Manual