Yamaha 01V Owner's Manual - Page 161
FREEZE Effect 2 only, that the previous sampler is deleted at this point.
View all Yamaha 01V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Effects Parameters 157 FREEZE (Effect 2 only) Basic Sampler with 2.9 second memory. Parameter Range Description REC MODE MANUAL, INPUT In MANUAL mode, recording is started by pressing the [ENTER] button. In INPUT mode, recording is triggered by an input signal. START *1 Playback start point in milliseconds [SAMPLE] 0-131070 Playback start point in samples PLY MODE MOMENT, CONTI., INPUT In MOMENT mode, the sample plays for the moment that the [ENTER] button is pressed. In CONT. mode, playback continues once the [ENTER] button has been pressed. In INPUT mode, playback continues once it's been triggered by an input signal. The number of times the sample plays is set using the LOOP NUM parameter. END *1 Playback end point in milliseconds [SAMPLE] 0-131070 Playback end point in samples LOOP NUM 0-100 Number of times the sample plays LOOP *1 Loop start point in milliseconds [SAMPLE] 0-131070 Loop start point in samples TRG LVL -60 to 0 dB Input trigger level (i.e., the signal level required to trigger recording or playback) TRG DLY -1000 to +1000 ms Recording delay. For plus values, recording starts after the trigger is received. For minus values, recording starts before the trigger is received. TRG MASK 0-1000 ms Once playback has been triggered, subsequent triggers are ignored for the duration of the TRG MASK time. MIDI TRG OFF, C1-C6, ALL Sample playback can be triggered using MIDI Note on/off messages. PITCH -12 to +12 semitones Playback pitch shift FINE -50 to +50 cents Playback pitch shift fine 1. 0.0-2972.1 ms (fs=44.1 kHz), 0.0 ms-2730.6 ms (fs=48 kHz) To record and playback a sample 1. Send a channel signal to Effect 2, and then recall the Freeze effect. See "Using the Effects" on page 123 and "Recalling Effects Programs" on page 134. 2. Use the [EFFECT 2] button to locate EFFECT 2 page 1, as shown below. 3. Select the (REC) switch, and then press the [ENTER] button. Note that the previous sampler is deleted at this point. The REC switch appears highlighted, and input signal can be heard. 01V-Owner's Manual