Yamaha 01V Owner's Manual - Page 248
V & TascamInterface Recorder
View all Yamaha 01V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
246 Chapter 18-System Examples 01V & Tascam-Interface Recorder This example shows how the 01V can be used with an 8-track digital tape recorder, or 8-track hard disk recorder, featuring a Tascam Digital Audio Interface (TDIF-1) connection to create a 16-input, 8-track fully digital recording system, with the 16 mic/line inputs and eight digital tape returns providing up to 24 inputs during mixdown. System Components • 01V Digital Mixing Console • MY8-TD Option I/O card • 8-track digital tape recorder, or 8-track hard disk recorder, such as the Tascam DA-38 Tascam DA-88, Tascam DA-98, or Akai DD8. • Tascam PW-88D digital audio cable See "Installing Option I/O Cards" on page 218 for MY8-TD installation instructions. Wordclock Configuration For digital audio transfer, digital audio devices must be wordclock synchronized (see "About Wordclocks" on page 206). In this example, the digital multitrack recorder is wordclock master and the 01V and DAT recorder are wordclock slaves. The 01V derives its wordclock from the Option I/O digital input. The DAT derives its wordclock from the Digital Stereo Coaxial Out of the 01V. The wordclock frequency, which is the same as the sampling rate, is set when the digital multitrack tape is formatted or first recorded. For digital recording from the DAT recorder to the digital multitrack recorder, the DAT recorder must be configured as wordclock master and the 01V and digital multitrack recorder as wordclock slaves. In this case, the 01V would derive its wordclock from the Digital Stereo Coaxial In connection. Since the digital multitrack recorder cannot derive a wordclock signal from its digital inputs, a BNC cable is used to supply a wordclock signal from the 01V. (Note that this connection is only necessary when the digital multitrack recorder is used as a wordclock slave.) The sampling rate will be the same as that used when the DAT tape was recorded. If a CD player is used instead of the DAT, the sampling rate will be fixed at 44.1 kHz, the industry-standard for music CDs. System Notes • The TDIF-1 connector on the MY8-TD is connected to the digital multitrack recorder using a Tascam PW-88D digital audio cable. • MY8-TD cards feature a device selector switch that should be set according to the type of recorder connected. "EXT: 88" for DA-88. "INT: 38" for DA-38 or other recorder. • Although the 01V is a four-bus mixer, a combination of bus outs, aux sends, and channel direct outputs can be assigned to the digital outputs for eight-track simultaneous recording. See "Assigning Option I/O Digital Outputs" on page 219 for more information. • The BNC wordclock connection from the 01V to the digital multitrack recorder is only necessary when the digital multitrack recorder is used as a wordclock slave. 01V-Owner's Manual