3Com 3C13886 Installation Guide - Page 138
Router 1-port Ce3 Fic
UPC - 662705478456
View all 3Com 3C13886 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
3Com Router Module Guide Chapter 4 T1 cable (100-ohm straight-through shielding network cable) Network interface connector RJ-45 Router DDN, etc RJ-45 St-raight-through cable Figure 4-29 Extending a T1 cable Step 3: Power on the router, and check the behavior of the LINK LED on the card panel: OFF means fault occurs on the line. Check the line status. 4.6 ROUTER 1-PORT CE3 FIC 4.6.1 Introduction ROUTER 1-PORT CE3 FIC, the 1-port channelized E3 interface card, delivers these functions: z In E3 mode, transmitting, receiving, and processing one channel of E3 fast traffic; providing E3 traffic access. z In CE3 mode, providing the subscribers with N x 64 kbps low-speed access, where N is smaller than or equal to 128. Note: E3 represents the tertiary group rate of E system in the TDM system, that is, 34.368 Mbps. Through E23 and E12 demultiplexing, an E3 channel can be channelized into 16 E1 lines, each supporting both the E1 and CE1 modes. E23 means either E2-to-E3 multiplex or E3-to-E2 demultiplex, and E12 means E1-to-E2 multiplex or E2-to-E1 demultiplex. "E23" and "E12" discussed here represent the demultiplex process. 4.6.2 Interface Attributes The following table describes the interface attributes of the ROUTER 1-PORT CE3 FIC. Table 4-15 ROUTER 1-PORT CE3 FIC interface attributes Attribute Description Connector SMB 4-29