3Com 3C13886 Installation Guide - Page 38
Introduction, Appearance, Step 4: Check the status of LINK LED on the ROUTER 1-PORT FRACTIONAL T1 SIC
UPC - 662705478456
View all 3Com 3C13886 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
3Com Router Module Guide Chapter 2 Smart Interface Cards If the SIC has been properly installed, follow these steps to connect the cable: Step 1: Connect one end of the T1 cable to the RJ-45 port of ROUTER 1-PORT FRACTIONAL T1 SIC; Step 2: Connect the other end of the T1 cable to the relevant equipment; Step 3: Power on the Router, and check the LEDs of the corresponding slot on the front panel: ON means that the SIC is operating normally and OFF means that the POST of the SIC has failed. In the latter case, please contact your agent. Step 4: Check the status of LINK LED on the ROUTER 1-PORT FRACTIONAL T1 SIC panel: ON means the link is connected and OFF means the link is not connected. In the latter case, check the line. 2.6 ROUTER 1-PORT ANALOG MODEM SIC 2.6.1 Introduction 1/2-port analog modem interface card (ROUTER 1-PORT ANALOG MODEM SIC) integrates the functions of asynchronous interface and external modem, that is, allowing 1/2 channel(s) of remote modem subscribers to directly access the Router. They support: z Data rate of 56 kbps. z Accessing and handling analog signals and transmitting the processed data to the Router host through the serial interface bus. And also, processing the data received from the host and then transmitting them to the PSTN via the telephone port. 2.6.2 Appearance ROUTER 1-PORT ANALOG MODEM SIC and are shown in the following figures: Figure 2-23 ROUTER 1-PORT ANALOG MODEM SIC 2-23