3Com 3C13886 Installation Guide - Page 142
Router 1-port E3 Atm Fic
UPC - 662705478456
View all 3Com 3C13886 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
3Com Router Module Guide Chapter 4 The following table describes the LEDs on the card panel. Table 4-18 LEDs on the ROUTER 1-PORT CT3 FIC panel LED Description LINK OFF means no link is present; ON means a link is present. OFF means no data is being transmitted or received on the interface; blinking means ACT data is being transmitted and/or received. 4.7.4 Interface Cable Refer to the section Error! Reference source not found."Error! Reference source not found.". The interface cable for the ROUTER 1-PORT CT3 FIC is the same as that for the ROUTER 1-PORT CE3 FIC and is connected in the same way. 4.8 8.8 ROUTER 1-PORT E3 ATM FIC 4.8.1 Introduction 8.8 ROUTER 1-PORT E3 ATM FIC, the 1-port 34Mbps ATM-E3 interface card, provides these functions: z Two ATM cell mapping modes: ATM direct mapping (ADM) and physical layer convergence protocol (PLCP). z Scrambling in data transmission. z Line clock (when working as DTE interface) and internal clock (when working as DCE interface). z Four types of test measures: local cell loopback, local loopback, remote payload loopback, and remote line loopback. Note: You may equip your router with 8.8 ROUTER 1-PORT E3 ATM FIC cards to its full capacity. Yet, you are recommended to install only one 8.8 ROUTER 1-PORT E3 ATM FIC on it, whatever its model is, to ensure performance of some key services. 4.8.2 Interface Attributes The following table describes the interface attributes of the 8.8 ROUTER 1-PORT E3 ATM FIC. 4-33