3Com 3C13886 Installation Guide - Page 157
ROUTER 1-PORT OC3 POS FIC, Panel and Interface LEDs, Interface Cable, Connecting the Interface Cable
UPC - 662705478456
View all 3Com 3C13886 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
3Com Router Module Guide 4.13.3 Panel and Interface LEDs Chapter 4 The following figures illustrate the ROUTER 4-PORT T1 IMA FIC panels: Figure 4-46 ROUTER 4-PORT T1 IMA FIC panel The following table describes the LEDs on ROUTER 4-PORT T1 IMA FIC panel: Table 4-30 LEDs on ROUTER 4-PORT T1 IMA FIC/ panel LED Description LINK OFF means no link is present; ON means a link is present. OFF means no data is being transmitted or received; blinking means ACT data is being received and/or transmitted. 4.13.4 Interface Cable The ROUTER 4-PORT T1 IMA FIC card provides four or eight T1 ports and uses the 4T1 conversion cable for connection. At one end of the cable is a DB-68 connector for connecting the router and at the other end are four or eight RJ-45 connectors for connecting other devices. 4.13.5 Connecting the Interface Cable Step 1: Insert the DB-68 connector of the conversion cable to the DB-68 port on the ROUTER 4-PORT T1 IMA FIC card. Step 2: Connect one RJ-45 connector at the other end of the cable to the device to be connected. Step 3: Power on the router. Check the behavior of the LINK LED on the card panel: OFF means fault has occurred on the link. Check the line status. 4.14 ROUTER 1-PORT OC3 POS FIC 4.14.1 Introduction ROUTER 1-PORT OC3 POS FIC, the 1-port SDH/SONET interface card, supports interface rates up to 155.52 Mbps. 4-48