3Com 3C13886 Installation Guide - Page 98
Table 3-33, Indication, OFF: Router NDEC2 Encryption Accelerator MIM runs normally and no data
UPC - 662705478456
View all 3Com 3C13886 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
3Com Router Module Guide Chapter 3 Multifunctional Interface Modules Table 3-33 Description of the LEDs on ROUTER NDEC2 ENCRYPTION ACCELERATOR MIMpanel LED Indication STATUS ON (green): The Router NDEC2 Encryption Accelerator MIM is powered on properly. OFF: There is no power supply, damaged power supply, or sever hardware failure. ACTIVE OFF after flashing yellow for two seconds: Initialized the Router NDEC2 Encryption Accelerator MIM. Blinking continuously: The Router NDEC2 Encryption Accelerator MIM operates normally and there is data transmission with the host. OFF: Router NDEC2 Encryption Accelerator MIM runs normally and no data transmission exists with the host. 3.13.5 Troubleshooting 1) Symptom 1: The STATUS LED stays off after turning on the router. Troubleshooting: The STATUS LED should stay solid on after powered on. The OFF status indicates that the Router NDEC2 Encryption Accelerator MIM or some hardware is not powered on properly. Check the connection of the power supply. If the device is powered on, the failure may due to the damaged power supply of the module, or abnormal operation of CPLD (Complex Programmable Logic Device). In these circumstances, contact our agents for support. 2) Symptom 2: The ACTIVE LED stays off when powering on the router. Troubleshooting: When powering up the device, the ACTIVE LED should flashing for two seconds before turning off, which indicates the encryption processor of the Router NDEC2 Encryption Accelerator MIM has been configured and is ready for work. If the ACTIVE LED stays on when powering up the device, this means the initialization of the processor fails and the system bus does not work normally. Check the connection between the Router NDEC2 Encryption Accelerator MIM and the host. If the connection is good, the abnormal status may due to the host or the Router NDEC2 Encryption Accelerator MIM, contact our agents for support. 3) Symptom 3: The ACTIVE LED stays on or off when the Router NDEC2 Encryption Accelerator MIM is running. Troubleshooting: The ACTIVE LED should be blinking when the Router NDEC2 Encryption Accelerator MIM runs the encryption service. The solid on or off indicates the system bus works abnormally. Check the connection between the Router NDEC2 Encryption Accelerator MIM and host. If the connection is good, the abnormal status 3-54