Adaptec 412R User Guide - Page 146
Advanced Configurations – DuraStor6320SS, RAID – 12-Drive Configuration
UPC - 760884139691
View all Adaptec 412R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
DuraStor 412R/6320SS/7320SS Installation and User's Guide Advanced Configurations - DuraStor 6320SS RAID - 12-Drive Configuration The DuraStor 6320SS can be setup to provide up to a 12 disk drive storage solution using the primary RAID enclosure only. 1 Remove the SAF-TE disk I/O card installed in both enclosures. See Replacing an I/O Card on page 5-21 for instructions. 2 Locate the switches on each card and set them as shown in either Figure C-4 or Figure C-5. There are two possible switch settings for this configuration. SAF-TE ID = 8/8 RAID Controllers = 6 & 7 Switch Settings AARSSBDR 0 1D0 1DLM UP (1) 1 2 3 4 5 6 7 8 DOWN (0) Slot 1 ID 1 Slot 2 ID 3 Slot 3 ID 5 Dual-Bus Mode Slot 4 ID 2 Slot 7 I D1 Slot 5 ID 4 Slot 8 I D3 Slot 6 ID 0 Slot 9 I D5 Slot 10 I D2 Slot 11 I D4 Slot 12 I D0 Drive IDs of the Drive Slots (Drive Channel Side) Figure C-4 Switch Setting - Option 1 SAF-TE ID = 15/15 RAID Controllers = 6 & 7 Switch Settings A A RS S BDR 0 1D0 1DLM UP (1) 1 2 3 4 5 6 7 8 DOWN (0) Slot 1 ID 9 Slot 2 ID 11 Slot 3 ID 13 Dual-Bus Mode Slot 4 ID 10 Slot 7 ID 9 Slot 5 ID 12 Slot 8 ID 11 Slot 6 ID 14 Slot 9 ID 13 Slot 10 ID 10 Slot 11 ID 12 Slot 12 ID 14 Drive IDs of the Drive Slots (Drive Channel Side) Figure C-5 Switch Setting - Option 2 The switch settings assign specific SCSI IDs to the drive slots as indicated, and reserve IDs 6 and 7 for the RAID controllers, and IDs 8 or 15 for the SAF-TE processors. C-4