Adaptec 412R User Guide - Page 66
Configuring a Single-Bus Module
![]() |
UPC - 760884139691
View all Adaptec 412R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
DuraStor 412R/6320SS/7320SS Installation and User's Guide Configuring a Single-Bus Module The DuraStor 412R drive enclosure can be configured to provide a continuous single SCSI bus when you need to address all of the disk drives on one SCSI bus. To set up the storage subsystem as a single-bus, you need to install the single-bus module, which is available as a separate item from Adaptec. Visit www.adaptec.com for ordering information. To configure the DuraStor 412R for a single SCSI bus: 1 Remove the controller cover plate. 2 Install the single-bus RAID controller and canister module (Figure 5-6) into the Controller 1 slot (Figure 5-7). Figure 5-6 Single Bus Module 5-8
![](/manual_guide/products/adaptec-6320ss-user-guide-670ae53/66.png)
5-8
DuraStor 412R/6320SS/7320SS Installation and User’s Guide
Configuring a Single-Bus Module
The DuraStor 412R drive enclosure can be configured to provide a
continuous single SCSI bus when you need to address all of the
disk drives on one SCSI bus.
To set up the storage subsystem as a single-bus, you need to install
the single-bus module, which is available as a separate item from
Adaptec. Visit
www.adaptec.com
for ordering information.
To configure the DuraStor 412R for a single SCSI bus:
1
Remove the controller cover plate.
2
Install the single-bus RAID controller and canister module
(
Figure 5-6
) into the Controller 1 slot (
Figure 5-7
).
Figure 5-6
Single Bus Module