Adaptec 412R User Guide - Page 79
Replacing an I/O Card, The I/O cards are
![]() |
UPC - 760884139691
View all Adaptec 412R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Understanding and Maintaining Components Replacing an I/O Card Warning: The I/O cards are not hot-swappable. You must power down the storage subsystem to remove or replace any I/O card. See Turning the Power Off on page 2-7. 1 Power off DuraStor. See Turning the Power Off on page 2-7. 2 Identify the faulty I/O card. 3 Disconnect the cables attached to the faulty I/O card. 4 Loosen the two thumb screws that secure the card. 5 Grasp the thumb screws and gently pull the I/O card from the storage subsystem. (You can use the handle on the SAF-TE disk I/O card instead of the screws.) 6 (SAF-TE Disk I/O only) Note the position of the jumpers and the switch settings on the faulty card. 7 Remove the new replacement card from the shipping container. Inspect the card for obvious damage. 8 (SAF-TE Disk I/O only) Set the jumpers and switches to match those on the faulty card being replaced. 5-21
![](/manual_guide/products/adaptec-6320ss-user-guide-670ae53/79.png)