Adaptec 412R User Guide - Page 25
Basic Configuration – DuraStor6320SS, reserving IDs 6 and 7 for the RAID controllers
UPC - 760884139691
View all Adaptec 412R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
DuraStor 412R/6320SS/7320SS Installation and User's Guide Basic Configuration - DuraStor 6320SS The DuraStor 6320SS can be set up to provide a storage solution with up to 12 disk drives. This configuration uses the primary RAID enclosure only. If you need to use more disk drives, you can add up to two additional 412R drive enclosures to the DuraStor 6320SS storage subsystem. To set up a basic 12-disk drive configuration 1 Power OFF the storage subsystem. See Turning the Power Off on page 2-7. 2 Remove the SAF-TE disk I/O card installed in the storage subsystem. (See Replacing an I/O Card on page 5-21 for instructions.) 3 Locate the switches on the card and set them as shown in either Figure 2-13 or Figure 2-14. The switch settings assign specific SCSI IDs to the drive slots, reserving IDs 6 and 7 for the RAID controller(s), and IDs 8 or 15 for the SAF-TE processors. There are two possible switch settings for this configuration. You may choose either setting to fit your needs. SAF-TE ID = 8/8 RAID Controllers = 6 & 7 Switch Settings A A RS S BDR 0 1D0 1DLM UP (1) 1 2 3 4 5 6 7 8 DOWN (0) Slot 1 ID 1 Slot 2 ID 3 Slot 3 ID 5 Dual-Bus Mode Slot 4 ID 2 Slot 7 ID 1 Slot 5 ID 4 Slot 8 ID 3 Slot 6 ID 0 Slot 9 ID 5 Slot 10 ID 2 Slot 11 ID 4 Slot 12 ID 0 Drive IDs of the Drive Slots (Drive Channel Side) Figure 2-13 Dual-Bus Switch Setting - Option 1 (DuraStor 6320SS) 2-12