Adaptec 412R User Guide - Page 53
Enclosure SAF-TE Monitoring
![]() |
UPC - 760884139691
View all Adaptec 412R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Monitoring DuraStor Enclosure SAF-TE Monitoring Another feature of DuraStor is the enclosure monitoring capabilities. The firmware-based monitoring program allows users to view storage system component status and information about the firmware. You may access this program by connecting a VT-100 terminal to the SAF-TE Service port. To access the monitoring program: 1 Connect one end of the null-modem RS-232 cable to the SAF-TE Service port located on the rear panel of the enclosure. Figure 4-4 Connecting the RS-232 Cable The cable is a female-to-female DB-9 null-modem cable. 2 Connect the other end of the cable to either a host system's serial communication port or a VT-100 type terminal. 3 On a host system, run a terminal emulation program or start the terminal. 4 Verify the communication parameters are as follows: I 9600 Baud (optional 19,200) Baud rate set by Switch 6 - up for 19,200 and down for 9,600 (verify the setting by pressing the Alarm Reset button and noting the condition of the drive status LED for drive slot 5. I 8 Data bits I 1 Stop bit I None (parity) I Flow Control Off 4-9
![](/manual_guide/products/adaptec-6320ss-user-guide-670ae53/53.png)