Adaptec 412R User Guide - Page 152
Replacing an I/O Card, Basic Connections, DuraStor 6320SS, Advanced Cabling
UPC - 760884139691
View all Adaptec 412R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
DuraStor 412R/6320SS/7320SS Installation and User's Guide 9 Configure the jumper settings on this second daisy-chain enclosure SAF-TE disk I/O card. Locate and add (installed on both pins) the two jumpers at JP7 and JP8. The default position of the jumpers are offset. 10 Reinstall the SAF-TE disk I/O card in each enclosure. See Replacing an I/O Card on page 5-21 for instructions. 11 Connect the SCSI data cables as shown in Figure C-8. SCSI Data Cable SCSI Data Cable Power Power Supply Supply Cooling Fans SAFTE Disk I/O Chl 1 Chl 2 SCSI Disk I/O Chl 0 Chl 3 Host I/O P1 P2 P4 P3 Ctlr 1 SAF-TE Ctlr 2 RAID Controller Primary enclosure Power Power Supply Supply Cooling Fans Power Power Supply Supply Cooling Fans SAFTE Disk I/O Chl 1 Chl 2 Ctlr 1 SAF-TE Ctlr 2 SAFTE Disk I/O Chl 1 Chl 2 Ctlr 1 SAF-TE Ctlr 2 First daisy-chain enclosure SCSI Data Cable Single Bus Module Second daisy chain enclosure Figure C-12 Enclosure Cabling Diagram 12 Connect a SCSI data cable from the host system(s) HBA(s) to the host I/O card as indicated in Basic Connections - DuraStor 6320SS on page 2-15 or Advanced Cabling - DuraStor 6320SS on page C-21. The configuration is complete. Refer to the Storage Manager Pro User's Guide or the Disk Array Administrator User's Guide for instructions on how to set up and configure disk arrays. C-10