Adaptec 412R User Guide - Page 153
Advanced Configurations – DuraStor7320SS, RAID – 24-Drive Configuration
![]() |
UPC - 760884139691
View all Adaptec 412R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
Advanced Configurations and Cabling Advanced Configurations - DuraStor 7320SS RAID - 24-Drive Configuration The DuraStor 7320SS can be setup to provide up to a 24 disk drive storage solution. In this configuration you will attach a DuraStor 412R to the primary RAID enclosure which will extend the drive channels (12 drives per channel). 1 Remove the SAF-TE disk I/O card installed in both enclosures. See Replacing an I/O Card on page 5-21 for instructions. Locate the switches on each card and set them as shown in Figure C-13. The switch settings assign specific SCSI IDs to the drive slots as indicated, and reserve IDs 6 and 7 for the RAID Controller(s) and IDs 8 or 15 for the SAF-TE processors. SAF-TE ID = 8/15 RAID Controllers = 6 & 7 Switch Settings A A RS S BDR 0 1D0 1DLM UP (1) 1 2 3 4 5 6 7 8 DOWN (0) Slot 1 ID 1 Slot 2 ID 3 Slot 3 ID 5 Dual-Bus Mode Slot 4 ID 2 Slot 7 ID 1 Slot 5 ID 4 Slot 8 ID 3 Slot 6 ID 0 Slot 9 ID 5 Slot 10 ID 2 Slot 11 ID 4 Slot 12 ID 0 Drive IDs of the Drive Slots (Drive Channel Side) Figure C-13 Switch Setting - Primary RAID Enclosure 2 Reinstall the SAF-TE disk I/O card in each enclosure. See Replacing an I/O Card on page 5-21 for instructions. C-11
![](/manual_guide/products/adaptec-6320ss-user-guide-670ae53/153.png)