Brother International BAS-375E Instruction Manual - English - Page 12
Installing the foot switch, 7. Installing the programmer box, 8. Installing the programmer
View all Brother International BAS-375E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Chapter 3 INSTALLATION 6. Installing the foot switch CAUTION Do not connect the power cord until installation si compleate, otherwise the machine may operate if the foot switch is depressed by mistake, which could result in injury. Be sure to attach the connector e of the foot switch w to the connector q whose cord comes from the center of q the front cover at the bottom of the machine. e w 7. Installing the programmer box w i u y r 1. Attach the programmer box q to the needle plate support w using the screws. 2. Be sure to attach the two connectors r and t to the respective receptacles on the rear of the floppy disk drive y. 3. Attach the connector u to the side of the programmer box q using the two screws i. t e q 8. Installing the programmer 1. Insert the cord q of the programmer into the connector w below the needle plate. q w 2. The programmer can be placed inside the box e. e BAS-364E, 366E, 370E, 375E 6