Brother International BAS-375E Instruction Manual - English - Page 22
Thread tension
View all Brother International BAS-375E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
6. Thread tension Chapter 4 CORRECT OPERATION Correct seam w Weaker Stronger Shorter Needle thread tension is too low Needle thread tension is too high Longer q Weaker Stronger e 1. Turn the adjustment screw q to adjust so that the length of the thread remaining at the needle point when the needle bar is at its highest position after thread trimming is 40 - 45 mm. 2. The bobbin thread tension should be adjusted so that when the thread is held the bobbin will not descend of its own weight. Turn tension screw w to adjust. 3. Turn tension screw e to adjust the needle thread tension. 6 - 8 mm Lower Higher r Weaker Stronger t 4. The standard operating range for the thread take-up spring (for heavy materials) is 6 - 8 mm. If adjustment is required, loosen the set screw r and then turn the needle thread tension adjuster. If adjustment of the thread take-up spring tension is required, turn the thread tension control stud t with a screwdriver. * Medium materials 3 - 5 mm Heavy materials 6 - 8 mm Air bags -1 - 2 mm BAS-364E, 366E, 370E, 375E 16