Brother International HL 1240 Service Manual - Page 153

CHAPTER 6 TROUBLESHOOTING P-2 Unable to print full pages of a document with the "PRINT OVERRUN" message. User Check (1) Press the panel button to print the data remaining in the printer. (2) If this does not clear the error, reduce the complexity of your document or reduce the printer resolution. (3) Expand the printer memory by adding a commercially available SIMM. (HL-1250 only) (4) Change the following setting in the printer driver and try again. The best combination of settings below will vary depending on your document. (HL-1250 only) Graphic Mode / TrueTypeTM mode / Use Printer TrueTypeTM Fonts. NOTE: This problem may appear if the data is too complex. If it is not cleared by taking the actions above, it will be impossible to print such data under the printer specifications. P-3 Unable to print full pages of a document with the "MEMORY FULL" message. User Check (1) Press the panel button to print the data remaining in the printer. (2) Reduce the complexity of your document or reduce the printer resolution. (3) Expand the printer memory by adding a commercially available SIMM. (HL-1250 only) NOTE: This problem may appear if the data is too complex. For the HL-1240 printer, if it is not cleared by taking the actions above, it will be impossible to print such data under the printer specifications. For the HL-1250 printer, take the following procedures. Possible cause Step Unable to 1 recognize SIMM SIMM / main 2 PCB failure Check Check the memory size in Print Configuration. Is it the default size? Try installing SIMM into another printer, then check the memory size in Print Configuration. Is it possible to print the data? Result Yes Yes No Remedy Expand the memory size by adding SIMM. If the memory is already at the maximum size, it will be impossible to print the data under the printer specifications. Replace the SIMM. Replace the main PCB. 6-43