Brother International HL 1240 Service Manual - Page 82

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY PR99156 (12) Remove the one M3x10 Taptite screw securing the halogen lamp connector plate at the drive unit side of the fixing unit frame and then loosen the M3x6 screw at the other side. (13) Lift the right hand end of the heat roller and remove the halogen heater lamp from the heat roller. Screw, cup M3x6 Heat roller Halogen heater lamp Colored side 115V: Yellow 230V: Purple Heat roller Halogen heater lamp Taptite, pan M3x10 Halogen lamp connector plate Fig. 4-34 ! CAUTION: • Never touch the surface of the halogen heater lamp. • When securing the screw to assemble the halogen lamp connector plate, ensure to use the plastic jig as shown in the figure below to avoid the edge of the halogen heater lamp damaged; Halogen lamp connector plate Taptite, pan M3x10 Halogen heater lamp Plastic jig Fig. 4-35 NOTE: When re-assembling the halogen heater lamp, ensure that the direction of the halogen heater lamp is correct referring to the figure above. 4-20