Brother International Innov-is 6000D Operation Manual - Page 103
Flat Fell Seam
View all Brother International Innov-is 6000D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
SEWING THE STITCHES c Pull the bobbin and upper threads out by 50 mm (approx. 1-15/16 inches) (see page 45). Flat Fell Seam Use for reinforcing seams and finishing edges neatly. a Select and attach presser foot "J". a Upper thread b Bobbin thread c About 50 mm (approx. 1-15/16 inches) d Sew two rows the seam line, of straight stitches parallel then trim excess thread to leaving 50 mm (approx. 1-15/16 inches). b Sew the finish line, then cut allowance from the side on half of which the the seam flat fell seam will lie. * When the automatic thread cutting and automatic reinforcement stitching are preset, reinforcement stitches will be sewn automatically at the beginning of sewing. Press the "Reverse/Reinforcement Stitch" button to sew a reinforcement stitch and trim the thread automatically at the end of sewing. 3 Utility Stitches a Seam line b 10 to 15 mm (approx. 3/8 inch to 9/16 inch) c About 50 mm (approx. 1-15/16 inches) e Pull the bobbin threads to desired amount of gather, obtain the then tie the threads. a About 12 mm (approx. 1/2 inch) b Wrong side c Spread the fabric out along the finish line. f Smooth the gathers by ironing them. a Finish line b Wrong side d Lay both seam allowances on the side of shorter seam (cut seam) and iron them. the g Sew on basting the seam stitch. line and remove the a Wrong side 89