Brother International Innov-is 6000D Operation Manual - Page 346

TROUBLESHOOTING Problem Fabric does not feed through the machine Fabric puckers High-pitched sound while sewing Character pattern does not turn out Cause Solution Page Feed dogs are set in the down position. 105 Press , and then turn the handwheel to raise the feed dogs. Stitches are too close together. Lengthen the stitch length setting. 67 Wrong presser foot was used. Use the correct presser foot. "STITCH SETTING CHART" Needle is turned, bent or the point is dull. Replace the needle. 56 Thread is entangled. Cut the entangled thread and remove it from - the race. There is a mistake in the upper or bobbin threading. Using improper needle or thread for the selected fabric. Check the steps for threading the machine and rethread it correctly. Check the "Fabric/Thread/Needle Combination" chart. 43, 46 58 Thread tension is set incorrectly. Adjust the thread tension. Stitches are too long when sewing thin fabrics. Shorten the stitch length. 67, 227 67 Needle is turned, bent or the point is dull. Replace the needle. 56 Spool cap is set incorrectly. Check the method for attaching the spool cap, 46 then reattach the spool cap. Wrong presser foot. Use the correct presser foot. "STITCH SETTING CHART" Dust or lint is caught in the feed dogs. Remove the dust or lint. 326 Pieces of thread are caught in the race. Clean the race. 326 Upper threading is incorrect. Check the steps for threading the machine 46 and rethread the machine. There are scratches on the race. Replace the race, or consult your authorized 326 dealer. A bobbin designed specifically for this machine Incorrect bobbins will not work properly. Only 43 is not used. use a bobbin designed specifically for this machine. Wrong presser foot was used. Attach the correct presser foot. "STITCH SETTING CHART" Pattern adjustment settings were set incorrectly. Revise the pattern adjustment settings. 153 Did not use a stabilizer material on thin fabrics or stretch fabrics. Thread tension is set incorrectly. Attach a stabilizer material. Adjust the thread tension. 152 67, 227 Fabric was pulled, pushed or fed at an angle Sew while guiding the fabric with your hands 60 while it was being sewn. so that the fabric is fed in a straight line. 332