Brother International Innov-is 6000D Operation Manual - Page 353

This message appears when the built-in camera is being used to align the embroidery position, but the embroidery positioning sticker is too near an edge or the pattern extends from the embroidery frame. Change the positioning of the embroidery position sticker, and then try aligning the position again. See page 206 or 302. This message is displayed when the upper thread is broken or not threaded correctly, and the "Start/Stop" button or the "Reverse/ Reinforcement Stitch" button is pressed. This message is displayed when the "Presser Foot Lifter" button is pushed while the presser foot lever is raised/ the needle is lowered. This message is displayed when the "Start/Stop" button is pushed to sew Utility stitches or Character/ Decorative stitches while the foot controller is connected. (This message does not appear when embroidering). This message is displayed when the "Start/ Stop" button is pushed while the machine is in embroidery edit mode and a pattern is being edited. ERROR MESSAGES This message is displayed when there is no stitch or embroidery pattern selected and the "Start/Stop" button or the "Reverse/Reinforcement Stitch" button is pressed. This message is displayed when the bobbin thread is running out. This message is displayed when the memory is full and the stitch or pattern cannot be saved. This message is displayed when the machine is retrieving a previously saved pattern while in embroidery edit mode. This message is displayed when, after selecting a pattern, , , or is pressed and the pattern is about to be deleted. 8 Appendix 339