Brother International Innov-is 6000D Operation Manual - Page 111
the presser foot and pull it out in the fabric
View all Brother International Innov-is 6000D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
e Position the cutter pin is side cutter so that the side aligned with the notch in the presser foot holder, and then lower the presser foot. SEWING THE STITCHES h Position the fabric so that the right side of the cut is on top of the guide plate and the left side of the cut is underneath the presser foot. a Notch in presser foot holder b Pin o The side cutter is attached. f Raise the presser foot and pull out a long section of the upper thread. Pass it below the presser foot and pull it out in the fabric feed direction. a Guide plate (lower knife) b Presser foot 3 c Upper thread Memo • If the fabric is not positioned correctly, the fabric will not be cut. Utility Stitches a Presser foot b Upper thread g Make a cut of approximately 20 (approx. 3/4 inch) in the fabric. mm a 20 mm (approx. 3/4 inch) 97