Brother International Innov-is 6000D Operation Manual - Page 350

ERROR MESSAGES This message is displayed when the automatic needle threading button is pushed while twin needle sewing is set. This message is displayed when the "Start/Stop" button is pressed before the edge of the fabric is detected. To detect the edge of the fabric using the built-in camera, press , raise the presser foot, and then perform the operation again. (see page 138) This message is displayed when the built-in camera cannot detect the edge of the fabric. If this message appeared after sewing has reached 1 to 2 cm (about 3/8 to 3/4 inch) from the edge of the fabric, refer to step m in "Edge Sewing" on page 144. If this message appeared during edge sewing, the edge of the fabric cannot be detected by the built-in camera. Press , raise the presser foot, raise the needle if it is lowered, and then perform the procedure described in "Edge Sewing" on page 140 starting from step f. If this error message appears again, sew without using edge sewing function. 336 This message appears when or is pressed to delete the settings for a utility stitch. To delete the selected settings, press . This message is displayed when an unusable embroidery card is inserted. This message is displayed when the "Reverse/ Reinforcement Stitch" button is pushed while the embroidery unit is attached. This message is displayed when the foot controller is pressed while the embroidery unit is attached and machine is set up for embroidering. This message is displayed when the patterns you are editing take up too much memory, or if you are editing too many patterns for the memory.