Canon PIXMA MG2120 User Manual - Page 589

Copying/Printing Stops Before It Is Completed Page 589 of 731 pages Home > Troubleshooting > Cannot Print > Copying/Printing Stops Before It Is Completed U322 Copying/Printing Stops Before It Is Completed Check 1: Has the machine been printing continuously for a long period? If the machine has been printing continuously for a long time, the print head may overheat. To protect the print head, the machine may stop printing at a line break for a period of time and then resume printing. In this case, wait for a while without operation. If the printing still does not resume, interrupt your print session at a convenient time and turn the machine off for at least 15 minutes. Caution The print head and the surrounding area can become extremely hot inside the machine. Never touch the print head or nearby components. Check 2: Is the paper loaded? Make sure that paper is loaded. If the machine has run out of paper, load paper. Check 3: Do the printing documents have lots of photographs or illustrations? As printing large data such as photos or graphics takes time for the machine and the computer to process, the machine may appear to have stopped operating. In addition, when printing data that uses a large amount of ink continuously on plain paper, the machine may pause temporarily. In either case, wait until the process is complete. Note If you are printing a document with a large printing area or printing multiple copies of a document, printing may pause to allow the ink to dry. Check 4: If copying stops before it is completed, try to copy again. If a certain time passes after some errors occurred while copying, the machine stops the operation. Page top