Canon PIXMA MG2120 User Manual - Page 600

Paper Does Not Feed Properly/"No Paper" Error Occurs Page 600 of 731 pages Home > Troubleshooting > Paper Jams/No Paper/Paper Does Not Feed Properly > Paper Does Not Feed Properly/"No Paper" Error Occurs U326 Paper Does Not Feed Properly/"No Paper" Error Occurs Check 1: Make sure that paper is loaded. Loading Paper Check 2: Make sure of the following when you load paper. When loading two or more sheets of paper, flip through the paper before loading. When loading two or more sheets of paper, align the edges of the sheets before loading. When loading two or more sheets of paper, make sure that the paper stack does not exceed the paper load limit. However, proper feeding of paper may not be possible at this maximum capacity depending on the type of paper or environmental conditions (either very high or low temperature and humidity). In such cases, reduce the sheets of paper you load at a time to less than half of the paper load limit. Always load the paper in portrait orientation, regardless of the printing orientation. When you load the paper, load the paper with the print side facing DOWN and slide the paper guides to align with the both sides of the paper. Loading Paper When you load the paper, insert the paper stack until the leading edge touches the far end of the front tray. Check 3: Check to see if the paper you are printing on is not too thick or curled. Media Types You Cannot Use Check 4: Make sure of the following when you load envelopes. When printing on envelopes, refer to Loading Paper, and prepare the envelopes before printing. Once you have prepared the envelopes, load them in portrait orientation. If the envelopes are placed in landscape orientation, they will not feed properly. Check 5: Confirm that the media type and the paper size settings correspond with the loaded paper. Check 6: If multiple sheets of plain paper is fed from the machine, select the setting for preventing double-feed of plain paper. If multiple sheets of plain paper is fed from the machine, select the setting for preventing doublefeed of plain paper using the operation panel or your computer. After printing is finished, disable the setting for preventing double-feed of plain paper; otherwise, the setting is applied from the next time. To set by using the operation panel