Canon imagePROGRAF TZ-30000 MFP Z36 imagePROGRAF TZ-30000 / TZ-5300 series Use - Page 139

Specifying the Cutting Method for Rolls How rolls are cut after ejection varies depending on printer settings. Note • Refer to the following for details on printer driver. "Cutting Roll Paper after Printing" (Windows) "Cutting Roll Paper after Printing" (macOS) • Refer to the following to print from a desired starting point. Paper cutting (to have the roll cut at your specified position) • Automatic cut (Top output) The roll is automatically cut by the cutter blade and ejected to the top. ◦ Driver Setting Automatic Cutting > Yes ◦ Output Location Setting Top Note • When Automatic Cutting is set to Yes and the output location is set to top for printing, automatic cutting is performed regardless of the printer settings. • Automatic cut (Front output) The roll is automatically cut by the cutter blade and ejected to the front. ◦ Driver Setting Automatic Cutting > Yes ◦ Output Location Setting Front ◦ Printer Setting Roll Paper 1/Roll Paper 2 > Paper settings > Advanced > Cutting mode > Automatic cut Important • If performing Automatic cut when ejecting to the front, the paper may become jammed or the printed surface may be scratched depending on conditions such as paper size and environment. In this case, perform Eject cut. • Eject (when the paper surface is being scratched / to wait for ink to dry) Select this to move the cutter by touch screen operation and cut paper. If performing Automatic cut when ejecting to the front, the paper drops and may rub against the basket, damaging the print surface. Support the paper so that it does not drop to avoid damage to the paper. Also, you can prevent paper that has not dried from dropping by visually checking the ink has dried, and then cutting the paper. 139