Canon imagePROGRAF TZ-30000 MFP Z36 imagePROGRAF TZ-30000 / TZ-5300 series Use - Page 437
Adjust feed length front, Print alignment pattern, Change adjustment values
![]() |
View all Canon imagePROGRAF TZ-30000 MFP Z36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 437 highlights
4. Tap Adjust feed length (front). 5. Tap Print alignment pattern or Change adjustment values. • If you tap Print alignment pattern: The test pattern is printed for you to measure the scale and calculate the discrepancy. The scale bar prints "Millimeter" in 50 mm increments and "Inch" in 1-inch increments. • If you tap Change adjustment values: No test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy. 6. Tap amount of discrepancy. If the scale is shorter than the actual size, use a positive setting value. If it is longer, use a negative value. The feed amount can be adjusted in 0.02% increments. 437
![](/manual_guide/products/canon-imageprograf-tz30000-imageprograf-tz30000-tz5300-series-user-manual-8e824a3/437.png)
4.
Tap
Adjust feed length (front)
.
4.
5.
Tap
Print alignment pattern
or
Change adjustment values
.
5.
•
If you tap
Print alignment pattern
:
•
The test pattern is printed for you to measure the scale and calculate the discrepancy.
The scale bar prints "Millimeter" in 50 mm increments and "Inch" in 1-inch increments.
•
If you tap
Change adjustment values
:
•
No test pattern is printed.
Instead, you will measure a document already printed to determine the discrepancy.
6.
Tap amount of discrepancy.
6.
If the scale is shorter than the actual size, use a positive setting value.
If it is longer, use a negative value.
The feed amount can be adjusted in 0.02% increments.
437