Canon imagePROGRAF TZ-30000 MFP Z36 imagePROGRAF TZ-30000 / TZ-5300 series Use - Page 163
reaches the platen.
View all Canon imagePROGRAF TZ-30000 MFP Z36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
Important • Even if you insert a sheet between the platen and the paper retainer, it is not fixed to the printer. If you release the sheet, it may fall inside the printer. Do not release the sheet until you lower the release lever. If the sheet falls, go to the back of the printer and remove it. Remove a Sheet that Fell into the Printer • Warped paper may rub against the print head. Straighten paper if it is warped before loading. Note • You can adjust the vacuum strength holding the paper against the platen when the release lever is up. If it is difficult to load the paper, tap Suction on the touch screen and adjust the vacuum strength. You can adjust the vacuum strength to 5 levels. • The suction remains on for about 30 seconds during loading. If you cannot finish loading a sheet during this time, pull the sheet away and reinsert it to start the suction again. 7. Feed a sheet between the platen and the paper retainer until the front edge of the sheet reaches the platen. 8. Insert the front edge of the fed sheet between the platen (A) and the roller (B). 163