Canon imagePROGRAF TZ-30000 MFP Z36 imagePROGRAF TZ-30000 / TZ-5300 series Use - Page 144
Paper settings, Advanced, Cutting mode, User cut, Do you want to set to detect the leading edge
![]() |
View all Canon imagePROGRAF TZ-30000 MFP Z36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Note • Once the following step has been performed, the procedure can be started from step 8 the next time. Printing the second and subsequent times Printing after replacing with the same type of paper 1. Tap paper settings display area on Home screen of touch screen. Note • If the Home screen does not appear, tap the HOME button. 2. Tap paper feed slot where roll paper for which you want to set cutting method is loaded. 3. Tap Paper settings. 4. Tap Advanced. 5. Tap Cutting mode. 6. Tap User cut. 7. When Do you want to set to detect the leading edge of the paper? is displayed, select Do not detect. Note • If you set the detection of paper leading edge to Do not detect, a margin of about 4.0 inches (10 cm) is created at the paper leading edge when printing starts. • When the detection of paper leading edge is set to Do not detect, printing will start at the position at which the roll was set for the first printing after replacing a roll. Thus, the margin of the paper leading edge will enlarge. (See "Loading Rolls in the Printer.") 8. Tap Back button twice to display roll paper screen. 144
![](/manual_guide/products/canon-imageprograf-tz30000-imageprograf-tz30000-tz5300-series-user-manual-8e824a3/144.png)