Cisco ESR10008 Hardware Installation Guide - Page 100

Removing and Replacing Field-Replaceable Units Chapter 5 Maintaining the Cisco 10008 Router Figure 5-6 Removing the Air Filter POWER FAULT MISWIRE 5 5 5 5 5 ACO CMRAIJTOICRAL MINOR SFATAILTUS ACO CMRAIJTOICRAL MINOR SFATAILTUS PROCESSOR ONLY OC-12/STM-4 POS SM-IR 6XCT3-DS0 6XCT3-DS0 6XCT3-DS0 PERFORMANCE ROUTING ENGINE PERFORMANCE ROUTING ENGINE 6XCT3-DS0 6XCT3-DS0 CH OC-12-DSO SM-IR GIGABIT ETHERNET 32220 Step 5 Pull out the filter tray far enough to remove the air filter (Figure 5-6). Figure 5-7 Inserting the New Air Filter OC-12/STM-4 POS SM-IR 6XCT3-DS0 6XCT3-DS0 6XCT3-DS0 PERFORMANCE ROUTING ENGINE PERFORMANCE ROUTING ENGINE 6XCT3-DS0 6XCT3-DS0 CH OC-12-DSO SM-IR GIGABIT ETHERNET POWER FAULT MISWIRE 5 5 5 5 5 ACO CMRAIJTOICRAL MINOR SFATAILTUS ACO CMRAIJTOICRAL MINOR SFATAILTUS PROCESSOR ONLY 32221 Step 6 Step 7 Step 8 Step 9 Step 10 Step 11 Place the new air filter in the tray so that you can see the directional arrows located on the metal frame (pointing up) and slide the tray into the chassis (Figure 5-7). Tighten the captive screws to secure the filter to the chassis (Figure 5-7). Slide the blower module back into the chassis making sure it securely connects to the backplane (Figure 5-12). The FANS OK LED should light (green). Tighten the captive screws on each side of the blower module (Figure 5-12). Return all interface cables through the cable management brackets. Replace the front cover if necessary (see the "Replacing the Front Cover" section on page 5-6). Cisco 10008 Router Hardware Installation Guide 5-8 OL-0659-13